English 
Tiếng Việt Properly storing iPhone charging cables will help you charge safely and extend the lifespan of your charging cable in the best way. So how do you protect your charging cable correctly, don't miss the suggestions below.
1. Unplug the iPhone charging cable from the outlet
Plugging the charging cable into the outlet when not in use can cause wasted electricity and reduce the lifespan of the charging cable. Therefore, unplugging the charging cable from the outlet will prevent damage, cable breakage, and cable explosions.
2. Unplug gently
This is the top criterion for preserving charging cables. Do not use strong force to twist or yank the cable out of the outlet; instead, hold the connector between the plug and the device, then unplug slowly and gently to avoid breaking the cable.
3. Store iPhone charging cables in a case
A small suggestion to help you better store your iPhone charging cable is to keep them in a case. This will limit tangling or breaking, and avoid negative impacts from the outside. It also makes it convenient for you to carry it anywhere.
4. Avoid bending iPhone charging cables
This is the ultimate taboo when using charging cables. Bending the charging cable will cause the internal circuits to break, thus making the charging cable unable to charge the phone.
5. Do not leave charging cables in damp places or high-temperature areas
One of the notes that users need to pay attention to when using iPhone charging cables is to avoid contact with damp environments (refrigerators, near the kitchen sink, etc.) or high-temperature areas (outdoors in the sun, near the stove). Because if the charging cable gets wet, it can cause a short circuit, and when the charging cable gets too hot, it can cause explosions.
7. Use Paracord
Paracord can be considered a very useful protective layer for charging cables. You can choose many different colors and patterns to create beauty for your charging cable. Wrapping the charging cable with Paracord is very simple, cut a piece of string the same length as the charging cable, then attach the narrowest end of the cable to the Paracord and slide it through the other cut end of the Paracord, so that the entire charging cable is covered by Paracord.
6. Use plastic wrap
Using plastic wrap to preserve charging cables and prevent breakage is a method that many people have successfully applied. You just need to wrap the wire around the charging cable, the plastic layer will cover the thin and soft cable, protecting the cable from breakage, and at the same time bringing an eye-catching appearance to the charging cable.
8. Use heat shrink tubing to wrap the cable
This is a popular method from the past. Heat shrink tubing is sold in many electronics stores. You just need to buy the rubber tube and attach it to both ends of the cable, use a hairdryer or heating device to tighten the cable. The nature of rubber tubing is that when exposed to high temperatures, it shrinks, helping the cable to be more sturdy and fixed.
9. Use a spring
Using a spring to wrap the charging cable is also a pretty good method. Take advantage of the spring from a ballpoint pen to wrap around the charging cable, this helps the cable to be limited from bending or kinking, leading to breakage.
10. Clean the charging cable properly
Cleaning the charging cable properly is also a measure to protect the iPhone charging cable. You need to remember the following steps:
– First, wrap the cable with a nylon bag and tie it tightly with a rubber band to prevent water from getting on the cable.
– Get a small basin, mix half a cap of Javel cleaning solution with a little water and stir well.
– Soak the wrapped charging cable in nylon for about 1 minute, do not soak for too long as it may damage the charging cable.
– Take out the charging cable, wipe it clean with a soft cloth, and avoid getting the cable wet.
Above are 10 ways to properly preserve iPhone charging cables that readers should refer to. Hope you will apply them successfully!
